Area 51 Scientists

Robert Lazars job at Area 51 didn't have a specific routine, he was met by a supervisor (CIA) and a security guard at the bus when it pulled up in front of the hanger. He was escorted to office building beside the hanger and given a stack of color coded files to review.

   The blue coded files  covered a diversified collection of UFO material, the information was unbelievable ! He wasn't able to learn everything from these files the information was compartmentalized. As hard as he tried to connect the dots it was difficult. He didn't believe anybody was privy to the complete information.

   The scientists weren't allowed to speak to each other and were at all ties under the watchful eye of the security people.

   The scientists were briefed on only what they needed to know, but you had a rough idea on what was going on.

    Robert lazar specifically dealt with propulsion systems, that is what he was specifically briefed on. Robert Lazar was able to learn that Area 51 was able to obtain a number of alien spacecraft. How they were acquired was not made clear !

   Robert lazar was able to review autopsy reports as well as black and white photo's of  alien bodies.  They were of the typical grays with large hairless heads, some showed the organs removed and spread out on a table, which listed thr weights and densities. Some of the organs had been cross sectioned .

   Robert Lazar was under the impression that he was being fed a little bit of information at a time, in preparation for something specific. Actual hands on experience with alien spacecraft.

    There had been several posters around the facility with a flying disc hoovering over the ground with the headline, “There Here” ! Robert Lazar saw a disc craft in the hanger but wasn't sure if it was there's or ours.

    The craft 35 ft in diameter, 15 ft high, it was resting on the ground, without any landing gear.

   Lazar was led into the hanger, after he spent a matter of time reviewing the files.  He was accompanied by a supervisor and a security guard, he was instructed not to look at the craft or say anything.

   After several months of working solely in the office area, he was allowed to view and enter the craft. It was made out of an alloy metal without any seams, rivets or joinery. It almost looked like it was made with a metal mold similar to the way a machinist would make a stainless steel mixing bowl. The craft seemed brand new.

   Lazar refereed to this craft as the sports model.  At the top it appeared to have small square port holes which appeared to have a dark almost black thick glass or Plexiglas type of material.

   Lazar felt that was where the control/pilot house/ bridge was located, but wasn't allowed onto the upper level of the craft.  The craft had three levels and the entrance was on the middle level.

    When one enters the craft the first thing you notice is the whole craft was the same color in and out.­ In the center of the craft there was a column going from the lower level through the overhead to the top level. The bulkhead inside of the craft had a archway similar to those in a Spanish style home.

    There was a control console that had been removed, another console and some small chairs some of which had also been removed.  At the bottom of the column was a small circular object that looked almost like a basketball.

     This object that looked like a basketball and was attached to the bottom of the center column was a anti-matter reactor. The column was hollow and was the wave guide for the reactor, we shall return to this in a moment.

   The interior was completely different than you would expect. The first thing you notice is that there aren't any sharp edges anywhere at all. The edges were all rounded almost like they were created with a router.

    You almost had the impression that you were in a child's playhouse. The chairs were very small almost like a child's chair, it was only a foot and a half off the ground. This craft which Lazar witnessed close up was not made in the United States this was an alien craft !

   This was an extraterrestrial vessel made with materials that we don't have on this planet. This spacecraft was made with knowledge and intelligence that we don't as of yet possess.

   The scientists were trying to reverse engineer and duplicate this craft with our modern knowledge. The problem is that they were encountering a whole new set of rules, laws of physics . To understand what was happening here you need to review Albert Einstein's theory of both General and Specific relativity.

    The inside buzz around Area 51 is that our scientists have already duplicated this technology using materials from mother earth, they have done so for over forty years now.